Replacing a power supply, Installation precautions and warnings – Brocade TurboIron 24X Series Hardware Installation Guide User Manual
Page 50
40
Brocade TurboIron 24X Series Hardware Installation Guide
53-1002981-01
Replacing a power supply
5
tp://www.fisfiber.com
When not using an SFP+ or SFP connector, make sure to keep the protective covering on.
Replacing a power supply
You can replace a power supply while the TurboIron 24X is powered on and running (if two power
supplies are installed). The power supplies are located in slots at the rear of the TurboIron 24X.
This section provides information about the following topics:
•
Installation precautions and warnings
•
Determining which power supply failed
•
Replacing a power supply
DANGER
Power supplies are hot swappable. However, Brocade recommends that you disconnect the
power supply from AC power before installing or removing the supply. The device can be running
while a power supply is being installed or removed, but the power supply itself should not be
connected to a power source. Otherwise, you could be injured or the power supply or other parts
of the device could be damaged.
Installation precautions and warnings
Follow these precautions when installing a power supply in the TurboIron 24X.
DANGER
Before beginning the installation, refer to the precautions in
CAUTION
Do not install the device in an environment where the operating ambient temperature might
exceed 40°C (104°F).
CAUTION
Never leave tools inside the device.