Brocade TurboIron 24X Series Hardware Installation Guide - Manual (Page 47)

Brocade TurboIron 24X Series Hardware Installation Guide 37
53-1002981-01
Chapter
5
Maintaining the TurboIron 24X Hardware
This chapter contains the following sections:
• Hardware maintenance schedule . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37
• Replacing a fiber optic module. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37
• Replacing a power supply . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40
• Replacing the fan tray . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45
Hardware maintenance schedule
This chapter provides instructions for maintaining the TurboIron 24X hardware.
DANGER
The procedures in this manual are for qualified service personnel.
The TurboIron 24X switch hardware components require minimal maintenance. TurboIron
recommends that you clean the fiber- optic connectors on fiber-optic ports and the connected fiber
cable each time you disconnect the cable.
You can replace the following hardware components as needed:
• Fiber optic modules (SFP+ transceivers)
• Power supplies
• Fan tray
Replacing a fiber optic module
You can remove an SFP or SFP+ from a port and replace it with a new one while the TurboIron 24X
is powered on and running.
This section provides information about the following tasks:
• “Removing a fiber optic module”
• “Installing a new fiber optic module”
• “Cabling a fiber optic module”