Installing the device, Desktop installation, Rack mount installation – Brocade TurboIron 24X Series Hardware Installation Guide User Manual
Page 25
Brocade TurboIron 24X Series Hardware Installation Guide
15
53-1002981-01
Installing the device
2
Installing the device
You can install Brocade TurboIron devices on a desktop or in an equipment rack.
DANGER
Make sure the rack or cabinet housing the device is adequately secured to prevent it from
becoming unstable or falling over.
DANGER
Mount devices in a rack or cabinet as low as possible. Place the heaviest device at the bottom
and progressively lighter devices above.
Desktop installation
Follow the steps for desktop installation.
1. Set the device on a flat desktop, table, or shelf. Make sure that adequate ventilation is
provided for the system. A 3 in. clearance is recommended on each side.
2. Proceed to
Rack mount installation
For rack mount installation, the Brocade TurboIron 24X supports the use of a two post Telco
equipment rack.
A rack mount kit with short mounting brackets ships with the device.
In addition to the rack mount kit, you will need the following tools for installation:
•
#2 Phillips-head screwdriver
•
Four 12-24 screws to mount the Brocade device in the rack.
DANGER
Make sure the rack or cabinet housing the device is adequately secured to prevent it from
becoming unstable or falling over.
DANGER
Mount the devices you install in a rack or cabinet as low as possible. Place the heaviest device at
the bottom and progressively place lighter devices above.