Yokogawa Removable Chassis DX1000N - Manual (Page 52)

0
IM 04L41B01-02E
Installation Procedure
Installation Procedure (Panel Mount Type)
Use a steel panel of thickness 2 mm to 26 mm.
1. Insert DX from the front of the panel.
2. Mount the DX to the panel using the mounting brackets that come with the
package as shown in the figure below.
• Use two brackets to support the top and bottom or the left and right sides of
the case (remove the seal that is covering the holes for the mounting brackets
beforehand).
• The proper torque for tightening the mounting screws is 0.7 to 0.9 N•m.
• Mount the DX to the rack according to the procedure below.
• First, attach the two mounting brackets and temporarily fasten the
attachment screws.
• Next, fix the DX in place by tightening the attachment screws with the
appropriate torque. When the DX is approximately perpendicular to the
panel as you fasten the screws, press the mounting bracket against the
case so that they are in contact with each other.
CAUTION
• Tightening the screws too much can deform the case or damage the bracket.
• Be careful not to insert foreign objects or tools through the holes for the
mounting brackets in the case.
Panel Mounting Diagram
Screw temporarily Fixed
Front
Panel
Panel
Mounting
brackets Mounting
brackets
Torque driver
(flat blade)
Attachment screw
DX case
In contact with
each other
(The figure shows the case when the mounting brackets
are used on the top and bottom of the case.)
Attachment
screw
Note
To achieve sufficient dust and water proof performance, mount the DX in the middle of the
panel cut out.
Installation (Desktop Type (/H[ ] Option)
The front (leg) stand can be pulled out.
CAUTION
On the desktop type, do not apply force to the DX when the front leg (stand) is
out. This can break the front leg.
Installation and Wiring