Yokogawa FVX110 - Manual (Page 63)

<8. Explanation of Basic Items (switching displays)>
8-2
IM 01S01C01-01EN
8.2 Continuous Scroll Mode
(scan mode)
To scroll display continuosly (scan mode), turn
the scroll knob about 180° or more in less than
a second. Scan mode operation is automatically
cancelled about 1 minute after start of operation.
To stop during operation, turn the scroll knob in the
opposite direction used to start continuous scroll
mode. During continuos scroll mode, an arrow icon
( or ) indicating the direction the scroll knob
is turned will appear in the lower right corner of the
display.
Automatically scrolling cycle will be the setting
of DISPLAY_CYCLE in LCD transducer block.
(Please refer to Table 7.3)
F0803.ai
Figure 8.3 Screen display during continuous
display switching
NOTE
Turning the scroll knob 180° is only rough
description. Thus even if a 180° turn of the scroll
knob fails to switch the displays, this is not a
malfunction. If a 180° turn of the scroll knob fails
to engage scan mode, try turning the knob faster.
8.3 Direction of Display
Switching
The direction of display switching by turning
the scroll knob can be changed by SCROLL_
DIRECTION setting of the LCD transducer block.
In the factory default setting, turning the scroll knob
clockwise increases the page numbers. For details,
refer to the instructions provided in the Section 7.3.