Option 48, Lucky option “+048 – Alliance Laundry Systems HWTB21 User Manual

Page 98

Programming NetMaster

210140

48. Lucky Option “+048”

This option allows the owner to program the machine
to provide a free vend cycle to customers after a
certain number of machine cycles have occurred.

For coin models, “FrEE” will be displayed five
minutes after the completion of the programmed
number of cycles has occurred. The cycle can then be
started by pressing the START (enter) pad.

For card models, when a card is inserted, the VFD will
display “bAL” followed by the card balance. When the
user presses the START pad, a zero vend will be
deducted from the card. The VFD will display
“WAIT”. The VFD will then display “FrEE” for five
seconds and then the cycle time will be displayed.
When the card is removed, the VFD will flash the
remaining balance for three seconds and will then revert
back to the cycle time.

How to Program Lucky Option

1. Control must be in Manual Mode. Refer to

Entering the Manual Mode.

2. Press the DELICATES (+) or the COLD (-)

keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.

Figure 174

3. Press the DELICATES (+) or the COLD (-)

keypad to scroll through the programmable
options until “+048” appears in the VFD. Refer
to Figure 175.

Figure 175

4. When “+048” appears in the VFD, press the

START (enter) keypad. A number will appear in

the VFD. This number corresponds to the current
Lucky Option Programming Value.

5. Locate the desired number in the first column of

Table 7 below.

6. Press the DELICATES (+) or the COLD (-)

keypad to increase or decrease the current
number until correct. Refer to Figure 176.

Figure 176

7. Press the START (enter) keypad when the

correct number appears in the VFD. The next
option, “+049”, will appear in the VFD.

NOTE: To program

“+049” (Special Cycle

Option), refer to option 49. To program other
options, refer to the appropriate section.

How to Exit Programming Feature

1. Be sure the control shows a programmable option,

not a value.

2. While pressing and holding the NORMAL

keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the ready mode. Refer to Figure 2.

C762I

C809I

“+048”

Lucky Option

Value

Lucky Cycle

ON/OFF

Number of

Cycles

1 – 127

OFF

1 – 127

129

130

131 – 255

3 – 127

Table 7

C860I

Press this pad (+) to scroll forward or increase a value

Press this pad (enter) to choose a selected value or
option

Press this pad (-) to scroll back or decrease a value