Alliance Laundry Systems HWTB21 - Manual (Page 96)

Programming NetMaster
210140 94 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
47. Control Configuration Data #3
“+047”
This option allows the owner to turn ON or turn OFF
preprogrammed capabilities within NetMaster.
How to Program the Control Configuration
Data #3
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES (+) or the COLD (-)
keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.
Figure 171
3. Press the DELICATES (+) or the COLD (-)
keypad to scroll through the programmable
options until “+047” appears in the VFD. Refer
to Figure 172.
Figure 172
4. When “+047” appears in the VFD, press the
START (enter) keypad. A number will appear in
the VFD. This number corresponds to the current
Control Configuration Data #3 Value.
5. Press the DELICATES (+) or the COLD (-)
keypad to increase or decrease the current
number to the desired number selected from
Table 6. Refer to Figure 173.
Figure 173
6. Press the START (enter) keypad when the
correct number appears in the VFD. The next
option, “+048”, will appear in the VFD.
NOTE: To program “+048” (Lucky Option), refer
to option 48. To program other options, refer to the
appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the ready mode. Refer to Figure 2.
C762I
c808i
C808I
C860I
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
1
3 2