Default cycle/temperature “+024 – Alliance Laundry Systems HWTB21 User Manual

Page 68

Programming NetMaster

210140

24. Default Cycle/Temperature

“+024”

This option allows the owner to set the default cycle
and temperature the machine will enter when in the
ready mode. When programming the default cycle,
refer to Table 3 on the following page.

How to Program Default Cycle/Temperature

1. Control must be in Manual Mode. Refer to

Entering the Manual Mode.

2. Press the DELICATES (+) or the COLD (-)

keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.

Figure 102

3. Press the DELICATES (+) or the COLD (-)

keypad to scroll through the programmable
options until “+024” appears in the VFD. Refer
to Figure 103.

Figure 103

4. When “+024” appears in the VFD, press the

START (enter) keypad. A number will appear in
the VFD. This number corresponds to the current
default cycle value.

5. Press the DELICATES (+) or the COLD (-)

keypad to increase or decrease the current number
to the desired number selected from Table 3 on
the following page. Refer to Figure 104.

Figure 104

6. Press the START (enter) keypad when the

correct number appears in the VFD. The next
option, “+025”, will appear in the VFD.

NOTE: To program

“+025” (Power Fail Reset),

refer to option 25. To program other options, refer
to the appropriate section.

How to Exit Programming Feature

1. Be sure the control shows a programmable option,

not a value.

2. While pressing and holding the NORMAL

keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the ready mode. Refer to Figure 2.

C762I

C788I

C860I

Press this pad (+) to scroll forward or increase a value

Press this pad (enter) to choose a selected value or
option

Press this pad (-) to scroll back or decrease a value