Entering the manual mode, How to enter the manual mode – Alliance Laundry Systems HWTB21 User Manual

Page 23

210140

Entering the Manual Mode

For programming, testing, and retrieving information
from NetMaster, it is often necessary to enter the
Manual Mode by following the four simple steps below.

How to Enter the Manual Mode

1. Be sure the washer is in the ready mode before

continuing to step 2. Refer to Figure 2. If the
washer is in an active cycle, rapid advance
through the cycle. Refer to Rapid Advance
Feature. If coins or a card has been entered, refer
to Clear Vend Feature.

2. Open the service door. Refer to Opening the

Service Door.

3. While pressing and holding the NORMAL

keypad with one hand, press the HOT keypad
with the other hand.

4. The VFD display will show “rAPd”. Refer to

Figure 4.

Figure 4

5. Press the DELICATES (+) or the COLD (-)

keypad to scroll through the options until the
desired option appears in the VFD.

6. Press the START (enter) keypad.

Manual Mode is broken into two groups: Manual
Programming and Manual Rapid Advance/Diagnostics.
Manual Programming can only be turned on or off
with the Micro-Wand IIIE, the Smart Card Reader or
the Network. Refer to the appropriate instruction
manual. Manual Rapid Advance/Diagnostics can be
turned on and off using the Micro-Wand IIIE, by
manual programming (refer to option 47 of
Programming NetMaster), with the Smart Card
Reader, or with the Network.

By default, both groups are turned “ON”.

The manual features available in each group are as
follows (the menu displayed on the VFD in this mode
is in parenthesis).

Manual Programming

Manual Programming (PrOg)

Manual Read Audit (AudT)

Manual Reset (rSET)

Rapid Advance/Diagnostics

Rapid Advance (rAPd)

Show Mode (SHOW)

Diagnostic Tests (dIAg)

If a group is turned “OFF”, the feature menu will still
appear, but the features in the group cannot be entered.

C834I