Alliance Laundry Systems HX User Manual
Washer-extractor, Ser v ice
Table of contents
Document Outline
- Cover
- Table of Contents
- Model Identification
- Safety Information
- Introduction
- Troubleshooting
- 1. WE-8 Control Has No Visible Display (P and N-Voltage Models)
- 2. WE-8 Control Has No Visible Display (Q and X-Voltage Models)
- 3. No Fill Analysis
- 4. Water Runs Continuously into the Washer-Extractor
- 5. Door Lock Switch Analysis: Display Shows “Door Error”
- 6. Door Lock Switch Analysis: Display Reads “Please Close Door”
- 7. Door Lock Switch Analysis: “Door Won’t Unlock”
- 8. No Output Voltage to Components
- 9. No Motor Operation With No AC Drive Fault
- 10. No Motor Operation With AC Drive Fault
- 11. The Motor is Running, But at an Abnormal Speed
- 12. No Spin
- 13. Machine Did Not Fill Alarm Analysis
- 14. Empty Alarm Analysis
- 15. Automatic Supply Dispenser Analysis
- 16. No Keypad Board Functions
- 17. Excessive Cycle Time
- 18. Excessive Vibration and/or Noise During Spin
- Service Procedures
- 19. Top Cover Removal and Replacement
- 20. Keypad Removal and Installation
- 21. Computer Board Removal and Installation
- 22. Keymode Switch Removal and Installation
- 23. AC Drive Switch Removal and Installation
- 24. Rear Panel Removal and Replacement
- 25. Side Panel Removal and Installation
- 26. Drive Belt Removal and Replacement
- 27. Water Valve Removal and Replacement
- 28. Drain Valve
- 29. Door Gasket Removal and Replacement
- 30. Motor Removal and Replacement (18, 25, 35, 55 and 75-Pound Capacity Models)
- 31. Motor Removal and Replacement (100, 135 and 165-Pound Capacity Models)