IEI Integration PM-LX2-800 - Manual (Page 65)

PM-LX2-800 User Manual
Page 65
4.8.5 TFT LCD Installation
The PM-LX2-800-R11 can be connected to a TFT LCD screen through the 40-pin TTL
screen on the board. To connect a TFT LCD to the PM-LX2-800, please follow the steps
below.
Step 5: Locate the connector. The location of the TTL connector is shown in Section
3.1.1.
Step 6: Insert the cable connector. Insert the connector from the TTL PCB driving
board to the TTL connector as shown in Figure 4-9. When connecting the
connectors, make sure the pins are properly aligned.
WARNING:
The diagram below is merely for illustration. The configuration and
connection of the cables from the TFT LCD screen being installed may
be different. Please refer to the installation manual that came with the
TFT LCD screen.