IEI Integration PM-LX2-800 - Manual (Page 54)

PM-LX2-800 User Manual
Page 54
WARNING:
A CPU should never be turned on without its heat sink being installed.
If the heat sink is removed and the system turned on, permanent
damage to the CPU, PM-LX2-800 and other electronic components
attached to the system may be incurred. Running a CPU without a heat
sink may also result in injury to the user.
4.3 Unpacking
When the PM-LX2-800 is unpacked, please do the following:
Follow the anti-static precautions outlined in Section 4.1.
Make sure the packing box is facing upwards so the PM-LX2-800 does not fall
out of the box.
Make sure all the components in the checklist shown in Chapter 2.3.1 are
present.
NOTE:
If some of the components listed in the checklist in Chapter 2.3.1 are
missing, please do not proceed with the installation. Contact the IEI
reseller or vendor you purchased the PM-LX2-800 from or contact an
IEI sales representative directly. To contact an IEI sales representative,
please send an email to [email protected].
4.4 SO-DIMM and CompactFlash® Installation
When purchasing SO-DIMM modules, the following considerations should be taken into
account:
The maximum SO-DIMM capacity supported is 1.0 GB
The maximum SO-DIMM frequency supported is 400 MHz
The SO-DIMM chip must be a 200-pin memory chip