Floppy drive connector, 2 floppy drive connector, Figure 4-2: connection of ide connector – IEI Integration NANO-LX v1.00 User Manual

Page 94

IEI

Technology, Corp.

Figure 4-2: Connection of IDE Connector

NOTE:

When two IDE disk drives are connected together, back-end jumpers on the

drives must be used to configure one drive as a master and the other as a slave.

4.3.4.2 Floppy Drive Connector

The floppy drive connector (CN34) provides access to one (1) externally mounted floppy

drive (3.5”-profile, 1.44 MB type floppy drive).

A 26-pin FPC connector cable is required for the connection to the floppy drive. The cable

should come with a 26-pin FPC-cable connector and floppy disk drive connector on the

other end. Follow the instructions below to connect an IDE HDD to the CPU card.

Plug the 26-pin FPC-cable connector into CN34. Make sure that the red wire

corresponds to pin one on the connector.

Step 1:

Step 2:

Attach the appropriate connector on the other end of the cable to the floppy drive.

Only one connector in the set can be used.

Step 0: