IEI Integration NANO-LX v1.00 - Manual (Page 85)

NANO-LX CPU Card
85
3.4.6 SERIRQ Select Jumper
NOTE:
Serial IRQ can only work properly if PCMCIA supports Serial IRQ signal.
Jumper Label: JP6
Jumper Type: 2-pin header
Jumper Settings: See Table 3-41
Jumper Location: See Figure 3-33
Use the JP6 jumper to reserve IRQ addresses for PCMCIA devices.
JP6 Description
Short SERIRQ Enable
Open SERIRQ Disable
Table 3-41: JP6 Jumper Settings
3.4.7 LCD Panel (LVDS/TTL) Voltage select Jumper
Jumper Label: JP7
Jumper Type: 3-pin header
Jumper Settings: See Table 3-42
Jumper Location: See Figure 3-33
The JP7 jumper sets the voltage to the LCD panel.
JP7 Description
1-2 Panel Voltage select 3.3V (Default)
2-3 Panel Voltage select 5V
Table 3-42: JP7 Jumper Settings