IEI Integration NANO-LX v1.00 - Manual (Page 203)

NANO-LX CPU Card
203
Use the arrow keys to highlight Delete All RAID Setting & Partition and press
E NTER .
Step 1:
Step 2:
Step 1:
Step 2:
Step 1:
Step 2:
The Data on RAID drives will be erased (Y/N) confirm box appears. Press Y.
Step 0:
E.5.7 Rebuild RAID Array
The Rebuild RAID Array option can rebuild a RAID array if a member of a RAID
configuration should fail. Neither RAID0 nor JBOD provides data redundancy. The Rebuild
RAID Array option only applies to RAID1 arrays and is applicable when a member of a
RAID1 configuration has failed.
Use the arrow keys to highlight Rebuild RAID Array and press E NTER . A
flashing ‘R’ appears at the list of existing arrays. The source and destination
drives will be displayed.
Press Y to begin the rebuild process. Step 0:
NOTE:
A status bar will indicate the rebuild progress. Rebuild consumes
considerable system resources and the time required for rebuilding a RAID
array may vary depending on the size of stored data, disk drive capacity, and
drive performance.
E.5.8 Select Boot Drive
Use the arrow keys to highlight Select Boot Drive and press E NTER . A flashing
‘A’ appears at the Drive Menu where the boot drive can be chosen.
Press E NTER or the space bar to finish the configuration. Step 0: