IEI Integration NANO-LX v1.00 - Manual (Page 130)

130 IEI ® Technology, Corp.
x Suspend Mode [Disabled]
The Suspend Mode option can only be selected if the Power Management option is set to
Legacy. The Suspend Mode specifies the amount of time the system can be inactive
before the system enters suspend mode. The Suspend Mode options are:
Disabled (Default)
1 Sec
5 Sec
10 Sec
15 Sec
30 Sec
45 Sec
1 Min
5 Min
10 Min
15 Min
30 Min
45 Min
60 Min
90 Min
120 Min
Soft-Off by PWR-BTTN [Instant-Off]
Use the Soft-Off by PWR-BTTN option to enabled the system to enter a very
low-power-usage state when the power button is pressed.
Instant-Off (Default) When the power button is pressed, the system is
immediately shutdown.
Delay 4-sec To shutdown the system the power button must be held
down longer than four seconds otherwise the system
enters a low power usage state.