IEI Integration IEM-9452 - Manual (Page 64)

IEM-9452 ETX Module
Page 48
way that the notch in the middle of the SO-DIMM must be aligned with the
plastic bridge in the socket.
Step 3: Insert the SO-DIMM. Push the SO-DIMM chip into the socket at an angle. (See
Figure 5-1)
Step 4: Open the SO-DIMM socket arms. Gently pull the arms of the SO-DIMM socket
out and push the rear of the SO-DIMM down. (See Figure 5-1)
Step 5: Secure the SO-DIMM. Release the arms on the SO-DIMM socket. They clip into
place and secure the SO-DIMM in the socket. Step 0:
5.3.2 Mounting the IEM-9452 Embedded Module
The IEM-9452 embedded module has four standard ETX connectors on the reverse side.
To install the IEM-9452 please refer to and follow the installation instructions below:
Step 1: Align the ETX connectors. Align the ETX connectors (ETX-X1, ETX-X2,
ETX-X3 and ETX-X4) with the corresponding connectors on a compatible
baseboard.
NOTE:
Baseboard can be designed by the end user, customized by IEI, or
purchased from IEI. For more information visit the IEI webstie
( www.ieiworld.com ) or contact an IEI sales representative.
Step 2: Gently insert the connectors. Gently push the embedded module down to
ensure the connectors are properly connected.
Step 3: Align the heat sink. Align the heat sink with the IEM-9452 making sure that the
three onboard chipsets are in proper contact with the heat sink. Also make sure
the retention screw holes on the corners of the heat sink are properly aligned