IEI Integration IEM-9452 - Manual (Page 44)

IEM-9452 ETX Module
Page 28
3.1 Anti-static Precautions
WARNING:
Failure to take ESD precautions during the installation of the IEM-9452
may result in permanent damage to the IEM-9452 and severe injury to
the user.
Electrostatic discharge (ESD) can cause serious damage to electronic components,
including the IEM-9452. Dry climates are especially susceptible to ESD. It is therefore
critical that whenever the IEM-9452, or any other electrical component is handled, the
following anti-static precautions are strictly adhered to.
Wear an anti-static wristband: - Wearing a simple anti-static wristband can
help to prevent ESD from damaging the board.
Self-grounding: - Before handling the board touch any grounded conducting
material. During the time the board is handled, frequently touch any
conducting materials that are connected to the ground.
Use an anti-static pad: - When configuring the IEM-9452, place it on an
antic-static pad. This reduces the possibility of ESD damaging the IEM-9452.
Only handle the edges of the PCB: - When handling the PCB, hold the PCB
by the edges.
3.2 Unpacking
3.2.1 Unpacking Precautions
When the IEM-9452 is unpacked, please do the following:
Follow the anti-static precautions outlined in Section 3.1.
Make sure the packing box is facing upwards so the IEM-9452 does not fall
out of the box.
Make sure all the components shown in Section 3.3 are present.