ZOLL Thermogard XP IVTM System Operation Manual - Manual (Page 45)

Operation
14
Figure 4-10. FEVER Mode Confirmation message
5. The Operating screen will be updated to reflect your selection.
NOTE: Target Temperature in FEVER Mode
The System keeps the bath cold and starts the peristaltic pump when the
patient temperature is greater than the target temperature
System Menu System
Main Menu
The main menu of the System is displayed in Figure 4-5 above. To call up the
main menu, press the knob from the operating screen. Some settings are
accessible only in Standby Mode.
The options available to you are as follows:
Table 4-3. System Main Menu
View Graphs Takes you to a display of the patient temperature data log. See:
Temperature Trend Data
New Patient Indicates to the System that you are starting a new patient case.
Downloading or deleteing the existing patient data log is required
End procedure Indicates to the System that you are finishing a patient case. You will be
prompted to save the existing patient data log. See: Ending Treatment
Settings Takes you to the Settings menu. See below
Exit menu Returns you to the operating display. The bath temperature meter display
will replace the menu.
600479-001 Rev 2 45/147