Agilent Technologies N2610A - Manual (Page 141)

Cable Testing in Expert Mode 5
The Expert Autotest Setup
Agilent FrameScope 350 User’s Manual 133
2 On the Autotest Setup screen press Edit Settings. On the Autotest
Settings screen press Save, then Edit to bring up the Save Mode
Setup screen. Press Summary Data Only or Full Data Set.
I‚‡r) DsГ’‚ˆГ†h‰rƈ€€h ’Ãqh‡hy’Г’‚ˆГvyyÁ‚‡ÃirÃhiyrǂà rpr ‡vs’Ãyh‡r Ðv‡uÇurÆh‰rqÃ
qh‡hÆvprÇurÃy‚‡†ÃvyyÁ‚‡ÃirÃh ‡Ã‚sÇurƇ‚ rqÃqh‡hȆrqÃs‚ à rpr ‡vsvph‡v‚Гi’Г
Tp‚ƒr9h‡hÃQ ‚
Setting the Storage Location
This is the same function as that shown in the System Settings
screen. Also when a CompactFlash™ card is inserted, this
function will automatically set the storage location to the
CompactFlash™ card See Configuring CompactFlash™ Cards,
on page 2-6.
Setting the Operator Names
The names of the technicians performing the tests can be
entered, and will appear on the test report. This is the same
function as that shown in the System Settings section See
Entering the Operator Names, on page 3-18. If it has been done
already there, it is reflected here.