IAI America NS - Manual (Page 68)

54
1
1. Maintenance
[6] Hook one end of the replacement wire on the wire hook (base side) whose screws have not been
loosened. Guide the other end of the wire under the motor and bring it to the mid-support, and hook
the wire on the delrin bearing at the mid-support. Next, pull the wire further to the motor and hook it
on the wire hook at the motor.
Hook one end of the replacement
wire on the wire hook.
Guide the replacement wire
under the motor.
Hook the replacement wire on
the delrin bearing by looping the
wire over the bearing from below.
Hook the replacement wire on
the wire hook (motor side).