IAI America NS - Manual (Page 63)

49
1
1. Maintenance
11.8 Adjusting the Mid-support Wire Tension
[Items required for adjustment]
Allen wrenches
Tension gauge (capable of exerting a push force of at least 1 kg (9.8 N))
[Procedure]
[1]
Remove the end cover using an Allen wrench of 1.5 mm across flats.
[2] Remove the screw cover using an Allen wrench of 2.0 mm across flats.
[3] Loosen the two screws (M3 x 5) affixing one wire hook (base side) of the mid-support wire located at
the center of the base, so that the wire hook can be moved.
Loosen the screws for only one wire hook on either the home side or counter-home side.
Wire hook
(base side)
Loosen the wire hook
on one side.