IAI America NS - Manual (Page 48)

34
8. Installation
8.4 Installing the Connector Box, and T-groove
On the nut rotary actuators of medium and large types, M4 T-grooves are provided on the side face of the
base for installing the connector box, cable track receiver and other items required by the combination
specification. (See the figure below.)
If the combined specification requires a wiring kit, use this T-slot to install the kit.
The T-slot can also be used to install sensors or secure wires or for various other purposes as deemed
necessary.
Caution: x Although square nuts are recommended, general hexagonal nuts can also be used with
the T-slot.
x When installing a bolt in the T-slot, pay attention to the bolt length to make sure the tip of
the bolt will not contact the bottom of the T-slot.