Gilderfluke&Co KP-300 Smart Brick Control Panel User Manual
Page 42
only the valid show selections. The eight ʻShow Pilotʼ outputs are
shown doing a simple circular chase pattern.
f) Whenever a
is programed to indicate that a
is valid, it is also necessary to actually enable
the corresponding
Show Start Button Enable Input
Brick System to make the
done, then the
will remain inactive. All eight
ʻShow Enablesʼ are ʻonʼ through the show, so all eight Show Start
Buttons are enabled.
g) The ʻ
ʼ is ʻonʼ through the show to reset any po-
tential ʻpausesʼ.
h) The
,
and
used during the Load/Unload show.
i) (optional) Open any cabin doors as needed. Sometimes cabin
doors are manually operated, sometimes they are automated. If
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Kp-300 Manual / September 4, 2012 4:29 PM / page 42 of 75