Sonnet Technologies Web Management Tool - Manual (Page 7)

1
Discovering the IP address
The Fusion RX1600Fibre is initially configured with DHCP enabled. It
is best if you have access to a DHCP server.
1. Work from the computer attached to the RX1600Fibre’s
Ethernet port. From the CD supplied with your RX1600Fibre,
run the
QuickNav Utility QuickNAV-windows.exe for
Windows or QuickNAV-Mac for Mac OS X.
2. Locate the RX1600Fibre with the serial number recorded
earlier.
3. Highlight the serial number.
4. Click Next. If a DHCP server is available on your network,
an address is assigned automatically by the server. Note the
assigned address. If you do not have a DHCP server, get an IP
address and subnet mask from your network administrator,
type it into the area provided, and click
Next. See Figure 1
on page 2.
5. Click Launch Browser. Your browser points to the Sonnet
Web Management Tool splash screen.
Optional - Setting up Internet Explorer
If you use Internet Explorer as a browser, you must configure it to
work with the Sonnet Web Management Tool. If not, continue on to
Beginning Initial Configuration.
1. Open your browser.
2. Select Internet Options.
3. In the Internet Options screen, select the Security tab.
4. Click the Trusted Sites icon.
5. Click the Sites button.
6. In the text box Add this Web site to the zone, add the IP
address of the controller. You may use wild cards.
7. Click Add.
8. Uncheck the Require server verification checkbox.
9. Click OK.
10. At the bottom of the Internet Options box, click OK and
close the box.
Beginning Initial Configuration
1. The Sonnet Web Management Tool interface splash screen
appears. Click Enter Here. See Figure 2 on page 2.
2. Type in the user name and password.
Note: The default values are user name root and password Password.
The user name is case insensitive and the password is case
sensitive. It is best practice to change the default user
name and password. Refer to Changing the Current User
Name, Password on page 17.
3. If the Fusion RX1600 was shipped from Sonnet with
hard drives preinstalled, the Health and Status Monitor
page appears. Otherwise, the Initial Setup page appears.
Continue to Ensure Drive Integrity on page 3.
1.0 Getting Started