beautypg.com

Appendix a - cli ascii-based interface – Sonnet Technologies Web Management Tool User Manual

Page 66

background image

x

IPDNSServer
Controls the current DNS Server address. If IPDHCP is enabled,
the DNS Server address is automatically detected. If IPDHCP
is disabled, you must set the address manually using this
command.

set IPDNSServer mp1 [xxx.xxx.xxx.xxx]
get IPDNSServer

IPGateway
Controls the current default gateways used by the
RX1600Fibre’s Ethernet port. If IPDHCP is enabled, the

get

command reports the current IP gateway assigned by the
network DHCP server.

Default: 0.0.0.0
set IPGateway [mp1] [xxx.xxx.xxx.xxx]

SaveConfiguration Restart command required

get IPGateway [mp1]

IPSubnetMask
Controls the current subnet masks used by the RX1600Fibre’s
Ethernet port. If IPDHCP is enabled, the

get command reports

the current IP subnet mask assigned by the network DHCP
server.

Default: 255.255.0.0
set IPSubnetMask [mp1] [xxx.xxx.xxx.xxx]

SaveConfiguration Restart command required

get IPSubnetMask [mp1]

IsReserved (Immediate)
Displays the reservation status of the current services session or
interface.

IsReserved

MaxOpTemp
Regulates or lists the maximum operating temperature. Valid
entries are from 55 through 70°Celsius.

Default: 70
set MaxOpTemp [55 – 70]

SaveConfiguration Restart command required

get MaxOpTemp

HSDisplay (Immediate)
Lists all drives in the Hot Spare pool.

HSDisplay

HSRemove (Immediate)
Removes a drive from the Hot Spare pool

HSRemove [BlockDevID | all]

IdentifyBridge (Immediate)
When enabled, the fault LED on this unit blinks so that
hardware may be identified. Disabling this option cancels the
blinking..

Default: disabled
set IdentifyBridge [enabled | disabled]
get IdentifyBridge

Info (Immediate)
Displays version numbers and other production information for
key components. Use the optional “brief” parameter to display
a more concise subset of system information.

Info

IPAddress
Controls the current IP address of the RX1600Fibre’s Ethernet
port. If IPDHCP is enabled, the get command reports the
current IP address assigned by the network DHCP server,
followed by the DHCP identifier.

Default: 10.0.0.1
set IPAddress [mp1] [xxx.xxx.xxx.xxx]

SaveConfiguration Restart command required

get IPAddress [mp1]

IPDHCP
Regulates how the unit acquires its IP address. When disabled,
the unit uses the IP address specified by the IPAddress CLI
command; when enabled, the unit gets its IP address from a
DHCP server.

Default: enabled
set IPDHCP mp1 [enabled | disabled]

SaveConfiguration Restart command required

get IPDHCP

Appendix A - CLI ASCII-Based Interface