4 monitor storage, configurations – Sonnet Technologies Web Management Tool User Manual
Page 25
19
1.4 Monitor Storage, Configurations
You may determine the performance of drives in the Fusion
RX1600Fibre or attached RX1600 Expansion systems using various
displays and tests in the Sonnet Web Management Tool.
The following instructions assume you have already set up at
least one RAID group. The ATTO FastStream controller in the
RX1600Fibre collects various metrics to measure performance
for physical drives during normal system operation and drive
initialization and verification.
Note: New performance data is updated every 60 seconds which
impacts performance slightly, even if you minimize the browser
window. Exit the Sonnet Web Management Tool completely
whenever you need maximum performance.
Health and Status Monitor Page
The
Health and Status Monitor page is the first page you
see when you open the Sonnet Web Management Tool after
completing the configuration of at least one RAID group. You
may return to it at any time by clicking the
Monitor button on
the left side of the window. See
Figure 17 on page 20.
1. If you’re not already in the Sonnet Web Management Tool,
type the IP address of your RX1600Fibre in a standard
browser. On the splash screen, click E
nter Here. In the box
provided, type in your user name and password, and then
click OK.
2. The Health and Status Monitor page appears. If you click
Details, additional information about each parameter appears
on the
Configuration Display page.
Configuration Display Page
Clicking
Details from the Health and Status Monitor page brings
up the
Configuration Display page. See Figure 18 on page 20.
Click the following links to view detailed information:
•
RAID groups: RAID group names, RAID status, available
Hot Spares, number of faulted drives, RAID level, number of
partitions, interleave and total capacity of each RAID group
•
Partitions: RAID group name, partition ID, capacity and block
size
•
Drives: Drive configuration by port, including drive size and
status
•
Interfaces: Ethernet management port link status and Fibre
Channel port link, speed, connection mode, node name and
port name
SCSI Enclosure Services (SES)
Fusion RX1600Fibre and Fusion RX1600 expansion enclosures
feature a SCSI Enclosure Processor which indicates enclosure health
status, drive identification and drive fault identification.
Use SES to identify individual drives, all the drives in the same
enclosure, all the drives in a single RAID group, or faulted drives.
Clicking
Details in the Enclosure Status section on the Health
and Status Monitor page brings up the SES Monitor page. Refer to
SCSI Enclosure Services (SES) on page 27.