Sonnet Technologies Web Management Tool - Manual (Page 54)

48
2.1 Interface Options
Using Telnet
Up to three Telnet sessions using the Fusion RX1600Fibre’s
Ethernet management port can be conducted simultaneously. A
serial port session can use the CLI while Telnet sessions are open.
Whichever session issues the first set CLI command that requires
a SaveConfiguration can continue to issue set commands, while
the other sessions can only issue get commands or display
information. Once a connection is established, refer to CLI
Provides an ASCII-based Interface on page i of the Appendix.
1. Connect to the RX1600Fibre from a computer on the same
Ethernet network.
2. Start a Telnet session.
Note: There is more than one way to connect to the FastStream using
a Telnet program. Your Telnet program may operate differently
than in the following instructions.
3. At the Telnet prompt, issue the open command
telnet > open x.x.x.x
where x.x.x.x is the IP address of the RX1600Fibre.
4. If you have to specify a port type, type in the port type
“telnet” and the terminal type “SC100”.
port type: telnet
terminal type: SC100
5. Type in the default values for the user name root and
the password Password if you did not set new values in
Changing the Current User Name, Password on page 17.