Securitron SAM2-24 User Manual
Securitron For Home
Securitron Magnalock Corp.
www.securitron.com
ASSA ABLOY, the global leader
Tel
800.624.5625
in door opening solutions
© Copyright, 2012, all rights reserved
PN# 500-10450
Page 1
Rev. B, 02/12
SHEAR ALIGNING MAGNALOCK MODEL SAM2-24
INSTALLATION AND OPERATING INSTRUCTIONS
1 INTRODUCTION
Securitron’s Shear Aligning Magnalock “SAM2-24” is a smaller, 24 Volt (only) version of the
original “SAM” Magnalock and is intended for installations where concealed mounting in the door
and frame is desired. As with the original SAM, the operating features allow self-alignment while
securing the door when it closes. The SAM2 is designed to operate with one-way swing, bi-
directional swing or sliding type doors. On swing type doors the lock installs horizontally in the
top or bottom of the door frame or may be installed vertically in the door frame side. For slider
type door applications the lock must be installed horizontally for proper operation. These units
have also been designed to unlock even if a preload is applied to the door.
2 SPECIFICATIONS
MODEL
SAM2-24
Holding Force
600 Lbs [272kg]
Dimensions: Length
7.2" [183mm]
Height
1.15" [29mm]
Depth
0.94" [24mm]
Voltage
24 Volts DC
Current @ 24 VDC
62mA
3 PRODUCT OVERVIEW
Upon unpacking this product, an inventory should be made to ensure that all the required
components and hardware have been included. Along with these instructions and the
installation template, each product should include the following items:
Figure 1 – SAM2-24 Magnalock
Magnalock
Strike Assembly
Hardware Pack