Securitron SASM KIT STRIKE User Manual
Sasm kit strike installation
Securitron Magnalock Corp.
www.securitron.com
ASSA ABLOY, the global leader
Tel
800.624.5625
in door opening solutions
© Copyright, 2011, all rights reserved
PN# 500-22140
Page 1
Rev. D, 03/11
SASM KIT STRIKE INSTALLATION
The 1/2” holes are each spaced 2-1/4” FROM THE CENTER HOLE
The hard rubber washer is an electrical insulator used to keep the strike electrically isolated form
the mounting framework and hardware. THE RUBBER WASHER MUST BE INSTALLED.
Use a 3/4” open ended wrench to hold the suspension bolt while tightening the strike mounting
screw.
The rear mounted roll pins in the existing or new strike must be replaced with the included 2-1/4”
long roll pins.
Patents
Securitron’s Shock Absorbing Strike Mount Kit is patent pending.
- ASB_Series (2 pages)
- ASCWB-DM62CL (4 pages)
- CWB_Series (2 pages)
- EASB_Series (4 pages)
- GDB (2 pages)
- HHD (6 pages)
- IK_Series (3 pages)
- M34R_Series (10 pages)
- M370 (16 pages)
- M38 (L, S and LS with D and T Options) (14 pages)
- M38 T UPGRADE (2 pages)
- M380BD_C_C2_X MAGNALOCK_Series (20 pages)
- M670 (16 pages)
- M680BDCX (16 pages)
- M32 (16 pages)
- Z-32 (2 pages)
- ZA-32 (3 pages)
- UHB (2 pages)
- TJ-38 (7 pages)
- TDK-1 (1 page)
- SWB-03 (2 pages)
- SMLS_SMSS (4 pages)
- SAM2C-24 (1 page)
- SAM2-24 (11 pages)
- SAM (16 pages)
- 32 REPLACEMENT STRIKE (1 page)
- UNL-12 UNLATCH (10 pages)
- STK-1 (2 pages)
- MUNL-12 (11 pages)
- MM15-TS (1 page)
- MM15 Z-Bracket_Series (1 page)
- MM15 (2 pages)
- Blind Nut (1 page)
- FSUNL_Series (2 pages)
- SCL-12 (4 pages)
- MCL-24 (8 pages)
- SWK (2 pages)
- SPK (2 pages)
- GL1 Quick Start (1 page)
- GL1 Install (10 pages)
- FMK-SW (7 pages)
- BPSS-10 (7 pages)
- PB5E (2 pages)
- PB5 (2 pages)