Securitron 82 REPLACEMENT STRIKE - Manual

Securitron Magnalock Corp. www.securitron.com
ASSA ABLOY, the global leader
Tel 800.624.5625 [email protected]
in door opening solutions
© Copyright, 2011, all rights reserved PN# 500-14700
Page 1 Rev. E, 06/11
REPLACEMENT STRIKE PLATE MOUNTING (MODEL 32, 62 OR 82)
Read and follow the template instructions which include drilling and mounting instructions.
Use the template provided for positioning and marking the mounting locations of the strike.
Check the external and internal areas of the marked door and frame for any obstacles such as
wire chases or internal structural features. Make necessary adjustments to avoid these
obstacles.
Offset strikes are available for lowering a strike alignment 1/4” [6.0mm] allowing clearance
when door construction contains obstructions in the mounting locations.
Figure 1
Be sure to apply the supplied thread-lock to the strike mounting screw threads. This
will prevent any loosening of the assembly over time (due to vibration for example) and yet the
screw can be removed by a serviceman.
When the strike is mounted, make sure it flexes freely around the washer stack. This
flexing allows the Magnalock to pull the strike into perfect alignment for maximum holding force.
LOCK/STRIKE INSTALLATION FOR “B” AND “D” MAGNALOCKS
IMPORTANT!
PLEASE READ AND APPLY THIS INFORMATION WHEN ALIGNING/INSTALLING THE
LOCK AND STRIKE. THE ALIGNMENT TOLERANCES INDICATED FOR EACH LOCK
MODEL ARE CONSIDERED CRITICAL FOR THE PROPER OPERATION OF BOTH THE
MAGNETIC BOND SENSING AND DOOR POSITION SENSING SYSTEMS!
SENSOR RANGES (PHYSICAL POSITIONING):
The BondSTAT “B” and DPS “D” Magnalock “Secure Zone” sensing ranges for each lock model
is listed in Table A.
(The Figure 2 illustration is a visual reference to the sensing ranges outlined in Table A).
NOTE: SPLIT STRIKES ARE NOT APPLICABLE FOR “D” DPS MAGNALOCKS
Secure Sensor Indication Range
(Dimensions from Center)
Model "X" (+/-) "Y" (+/-)
M32B/D 9/32" 1/8"
M62B/D 5/16" 1/8"
M82B/D 9/16" 1/8"
Table A
(+)
(+)
(-)
(+)
(-)
(-)
(+)
(-)
X
Y
0
0
Figure 2
Strike Plate
2-3 Washers
2X Roll Pins
Strike Mounting
Screw
Use Strike Bushing
for standard models
-OR-
Use Flat Nylon Washer
for 32 Split Strikes ONLY
2X Roll Pin Bushings
Door Frame & Stop
Sex Bolt