Reese 30126 RAIL KIT - Manual (Page 7)

30126N 03/16/11 REV E PCN15022 ©2011 CEQUENT PERFORMANCE PRODUCTS, INC. PRINTED IN USA
7
17. Loosely attach frame brackets (#2 & 3) (Figure 1) to mounting kit rails using 5/8” X 1 3/4” (#10) (Figure 1) long
bolts, conical washer (#11) (Figure 1) (below bracket), conical washer (#11) (inside rail), and 5/8” nut (inside rail)
(#9) (Figure 12) . Tighten all mounting kit bolts to hand tight.
CAUTION:
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural
members, etc. CEQUENT PERFORMANCE PRODUCTS, Inc. does its best to communicate tow vehicle
manufacturer changes; however, it is ultimately the responsibility of the installer to prevent damage due to
installation.
18. Loosely attach frame bracket to existing holes in chassis frame using M14 1.5 x 45 bolts (#10), conical washer
(#11) (Figure 1) , and flange nut (#12) (Figure 1) . Tighten to hand tight ( Figure 13 ). Lifting truck bed gives easier
access to the driver’s side nut and bolt.
Figure 12
Figure 13
Step 16D : One rail should be facing rearward and the other rail facing forward after the
installation. The rails should be centered with both ends of each rail resting
evenly on the frame.
WARNING:
DO NOT lubricate bolt threads. It may cause bolt failure.
Front