Getting connected – Audiovox SMT5600 User Manual
Page 99
Smartphone User Manual
5.
Getting
Connected
Smartphone User Manual
5.
Getting
Connected
98
99
To accept a bond:
1.
Make sure that Bluetooth is turned on and in Discoverable
mode.
2.
When prompted to bond with the other device, select
Yes.
3.
In
PIN, enter a PIN of between 1 and 16 characters, and
select
Done. You must enter the same PIN that was
entered on the device requesting the bond.
4.
Optionally, you can enter the name of the device requesting
the bond in the
Name field.
5.
Select
Done. The bond is now created. You can now
exchange information with the other device.
To delete a bond:
1.
Select
Settings > Bluetooth > Bluetooth from the Start
menu.
2.
Select
Devices from the menu.
3.
Select the bond you want to delete, then select
Delete
from the menu.
NOTE: Select
Settings > Bluetooth > BT Setting to enter a
name for your device; to enable/disable Beam Authentication
requirements; or perform ActiveSync setup (bond with other
Bluetooth device which supports serial port or ActiveSync
profile as your ActiveSync partner).