E-Mon E-PS-A-RTU-N - Manual (Page 52)

Chapter 3 Display
O P E R A T I O N S M E N U O P E R A T I O N S
52 PowerSmart+ Advanced Power Quality Meter
Label Parameter Options Default Description
Uolt Primary/Secondary
volts units Pri, SEc Primary Selects primary or secondary
units for volts display
Ph.P Phase powers
display mode diS, En Disabled Disables or enables phase
powers in the main display
Fund. Fundamental
component display
mode diS, En Disabled Disables or enables
fundamental values in the
main display
dAtE Date order dnY, ndY,
Ynd
(d=day,
n=month,
y=year) mm.dd.yy Defines the date order in the
RTC display
rSt Simple reset mode PASS =
password
required
En =
enabled PASS PASS = the simple reset is not
allowed when password
protection is enabled
En = enables the simple reset
buttons regardless of
password protection
SoFt. Display firmware
version N/A N/A Shows display firmware
version, like 1.2.8
SoFt. Device firmware
version N/A N/A Shows device firmware
version, like 15.01.09
Meter Security Meter Security Meter Security Meter Security
The Access Control menu allows you to change the user password and enable or
disable password protection. To enter the menu, select the “AccS” entry from the
main menu and press the ENTER button.
The password in your meter is preset to 0 at the factory, and password protection is
disabled.
To change the password:
Select the “PASS” entry in the upper window with the UP and DOWN arrow buttons.
Press the SELECT button to activate the first password digit.
Use the UP and DOWN arrow buttons to adjust the digit.
Press the SELECT button to advance to the next digit.
Adjust the remaining password digits.
Press ENTER to confirm your new password.
Your new password is effective for both the display and communication ports.
To enable or disable password protection:
Select “CtrL” in the upper window using the UP and DOWN arrow buttons.
Press the SELECT button to activate the middle window.
Use the UP and DOWN arrow buttons to select the desired option. “On” enables
password protection, “OFF’ disables password protection.
Press ENTER to confirm your new setting, or ESC to discard changes.
To exit the menu, press ESC.
When password protection is enabled, you are not allowed to change the
device settings through the display or communications unless you provide a correct
password. If you cannot provide a proper password, contact your local distributor for
the appropriate password to override password.
Entering a wrong password three times in succession for five minutes is treated
as a tampering attempt and is recorded to the device event log.
Power
0000
AccS
ESC
CtrL
On