Micromod MOD: 30ML Controller Operation and Maintenance Training Manual - Manual (Page 34)

Training Manual
Single Loop Template Lab
3 - 12
We will change the system tune and configuration passwords in this section.
1 Press DOWN
TUNE PASSWORD
is displayed on lines 1 and 2.
2 Press UP key to set 1 as password then
press ENT. Enter a number required to access tuning
parameters.
3 Press NXT
CONFIG PASSWORD
is displayed on lines 1
and 2.
4 Press UP arrow to set 2 as Configure
password. Press ENT This was a password established which is
required to access configuration parameters
5 Press NXT
6
ACCESS TIMEOUT
is displayed on
Lines 1 and 2.
0-54 minutes; 0=infinite. The time in minutes
that the tune and configure access levels will
timeout and return to the operate level after
last keyboard activity.
7 Press UP to change line 6 to the number
5. Press ENT This will give us 5 minutes before the tune and
configure access levels will timeout and return
to the operator level after the last keyboard
activity.
Figure 3 .12.
8 Press NXT
9 Press UP System (password exit)
10 Press NXT
SYSTEM ALARMs
displayed on lines 1 and 2