Micromod MOD: 30ML Controller Operation and Maintenance Training Manual - Manual (Page 26)

Training Manual
Single Loop Template Lab
3 - 4
3.3.3 Front face Configuration Map:
The front face configuration map shows an overview of the menus available front the front
oh the MOD 30ML controller. The major menu items at the top level are: These menu
items can be scrolled through, by selecting NXT from the front face while DEVICE is
displayed on line 1.
1. DEV STAT – This menu allows you to the following sub menus: The sub menus are
reached by pressing the DOWN arrow from the main menu.
• INSTSATE – Read and change instrument state
• SHUTDOWN – Read and acknowledge the instrument shut down
• COMMANDS – Issue commands like acknowledge alarms, clear event queue,
delete and restore main database etc., to the controller
• XTIME – Read the scan times
• TIME – Read and setup the real time clock of the controller
• DATE – Read and setup the real time date of the controller
• DAY – Read and setup the real time day of the week of the controller
2. SETUP – This menu is further divided into the following sub menus
• BI COMM – Setup built-in communication port parameters and instrument
address
• PASSWORD – Setup configuration and tuning password for the controller
3. I/O – Read I/O and change outputs
4. EVENTS – Read and clear system event queue
5. ABOUT – Read the controller and display firmware revision levels
6. TEMPLATE – Read and edit System compound for system parameters and insert and
edit user templates for configuring Single loop and Cascade PID control loops. This
menu has the following sub menus:
• System Compound
• User Compounds
The front face configuration map is shown in appendix. You can use this map for
reference and as a navigation tool for going through and setting up the menus and
configuration from the controller front face.