Micromod MOD: MODCELL Multiloop Processor 2002N Model C and Associated Hardware - Manual (Page 27)

MODCELL Multiloop Processor
MECHANICAL INSTALLATION
2.4.1 2002N Multiloop Processor - Flush Mount
The flush mount processor can be mounted directly in a rack or panel. Assure that
electrical wire routing and and support are planned as required for each processor. Mount
the processor as follows:
1. Mount the processor, Figure 2-5, in any available position in a rack or panel. Ensure
that the mounting screws provide good metal to metal contact between the processor
and its mounting surface.
NOTE: Good electrical contact between the processor and rack is important because
the large metal mass of the rack provides a good noise ground for the
processor.
2. Connect wiring to the processor terminals (see Section 3, Connection Guidelines).
Figure 2- 1 . Mounting Dimensions, 2002N Processor - Flush Mount
2 1