Micromod Micro-DCI: 53ML5100A LOADING STATION - Manual (Page 13)

1.4 SPECIFICATIONS
Table 1-1. Specifications
Item Specification(s)
Power Requirements (as specified) 22 - 26 V dc
108 - 132 V rms
216 - 264 V rms
50/60 Hz
Power Consumption (ac/dc operation) 36 VA maximum
Internal Power Supply:
Available Power Output for Transmitters
Output Ripple
25 V dc
±
1 V dc @ 80 mA maximum, short
circuit protected.
200 mV p-p maximum
Analog Input (ANI0&1) Signals (all analog in-
puts are referenced to signal common)
Quantity
Signal Range
Input Impedance
Measurement Accuracy
2 (ANI0 and ANI1)
0 - 5 V dc or 1 - 5 V dc (0 - 20 mA and 4 - 20
mA dc respectively).
Note: The rear terminal board has the
appropriate resistors for ANI0 and ANI1.
1 megohm minimum for voltage inputs; value of
ranging resistor for current signals.
±
0.1% of span
Analog Output (ANO0&1) Signals (is refer-
enced to power common)
Quantity
Signal Range
Load Range
Accuracy
2 (ANO0 and ANO1)
0 - 20 mA dc (4 - 20 mA dc typically)
0 - 750 ohms
± 0.2% of span
Sampling and Update Attributes:
Program Scan Rate
Analog Input Signal Sampling Rate
Display Update
Output Signal Update
0.05 seconds
0.05 seconds
0.10 seconds
0.05 seconds
Section 1. Introduction
1-9