beautypg.com

Heat, Decontamination procedure – Luminex FLEXMAP 3D User Manual User Manual

Page 17

background image

FIGURE 5.

Fuse Caution Label

The following voltage label appears on the back of the FLEXMAP 3D

®

instrument. It displays

the FLEXMAP 3D

®

serial number, model number, power requirements, and manufacturer’s

information.

FIGURE 6.

Serial Number and Voltage Label

Heat

The heater plate, used to warm the heater block of the XY platform, can be heated between
35°C and 60°C.

WARNING:

The heater plate of the Luminex

®

FLEXMAP 3D

®

XY platform

may be hot and can cause personal injury if touched. Do not
touch the heater plate.

Decontamination Procedure

Occasions may arise when it becomes necessary to decontaminate the entire Luminex

®

FLEXMAP 3D

®

instrument, for example, prior to shipping. If you must decontaminate the

instrument, sanitize the accessible surfaces and the internal fluidics system. This is
particularly important when biohazardous samples have been run.

For research use only. Not for use in diagnostic procedures.

Safety

7