beautypg.com

Lasers, Laser warning label, Avoid exposure label – Luminex FLEXMAP 3D User Manual User Manual

Page 14

background image

WARNING:

Do not use this device in close proximity to sources of strong
electromagnetic radiation, for example, unshielded intentional
RF sources, as these may interfere with proper operation

WARNING:

Always handle the FLEXMAP 3D

®

system according to Luminex

instructions to avoid any possible interference from its
electromagnetic fields.

Lasers

The Luminex

®

FLEXMAP 3D

®

instrument is classified under FDA 21 CFR 1040.10 and

1040.11 as a Class I laser product consisting of two Class IIIb lasers within the instrument.
The optional bar code reader is a Class II stand-alone component. In accordance with IEC
60825-1, the instrument is classified as Class 1, containing two Class 3b lasers. The optional
bar code reader is a Class II stand-alone component. The FLEXMAP 3D

®

complies with IEC

60825-1 and 21 CFR 1040.10 and 1040.11 except for deviations pursuant to Laser Notice
No. 50, dated June 24, 2007.

The following label appears on the back of the FLEXMAP 3D

®

instrument.

FIGURE 3.

Laser Warning Label

The following label appears above the laser apertures located inside the optics enclosure
inside the FLEXMAP 3D

®

instrument.

FIGURE 4.

Avoid Exposure Label

All Class 3b laser apertures are located within the FLEXMAP 3D

®

instrument and are

contained within a protective housing, accessible only to trained field service technicians.
When performing routine maintenance, turn power to the system off and disconnect the
power cord.

DANGER:

Do not, under any circumstances, remove the FLEXMAP 3D

®

instrument cover. Use of controls or adjustments or performance

Luminex

®

FLEXMAP 3D

®

Hardware User Manual

4

For research use only. Not for use

in diagnostic procedures.