Magnum Venus Plastech Flex Molding Process MKVI Mix - Manual (Page 21)

MKVI Mix Meter System Operations Manual
Rev. 08/2013 Page | 21
Stroke Counter (PDC):
The pre-determining 5 digit counter contains two readouts. The upper readout displays
the machine output count during injection. The lower readout displays the Preset count
entered by the operator. Each digit represents approximately 100cc (0.1 litres) of resin
displaced.
To pre-set the counter, push white arrow lever on counter down and whilst holding down
- set the predetermined amount of strokes required with the individual digit buttons and
then release the white arrow lever. (Range 0 - 999.9 litres)
NOTE: The machine cannot be started in inject mode, if a previous injection has
stopped automatically when the shot count has been reached and the stroke count
has not been reset. Press the reset button on the predetermining counter to reset the
count and allow the machine to be started.
Solvent Flush Button:
Activates the machine solvent flush cycle for approximately 30 seconds
Air Purge Button:
Air purges excess resin\solvent from the injection head.
MPG Preset Level Gauge:
Indicates the maximum injection pressure selected by the operator
MPG Preset Regulator:
Adjusts maximum injection pressure, with reading shown on MPG preset level gauge.
Count Reset Button
Press and hold when
adjusting preset count Use these black buttons to
adjust preset count
Stroke count
Preset count