Liquid Controls WinHost Operation - Manual (Page 11)

11
Utilities
Issue Command
The Issue Command section of LCR Utilities allows the
user to send a command or view the status of the se-
lected LectroCount register.
LCR Node #
Enter the node address of the LectroCount register.
Command
Select a command from the List Box Window. This com-
mand will be sent to the LectroCount register when the
operator clicks on Issue. The options from this List Box
Window are:
RUN
STOP
PRINT
S/PRINT
Issue
After selecting the desired command, click on Issue to
send the command to the LectroCount.
LCR Status
Click on LCR Status to open the status window of the
LectroCount register.
Change Node Address
This section allows the operator to change the node ad-
dress of the LectroCount register. All new registers from
the factory have a default node address of 250.
Old
Enter the current node address of the LectroCount reg-
ister.
New
Enter the new node address for the LectroCount regis-
ter.
Change Node Address
Click on Change Node Address to change the node ad-
dress for the LectroCount register from the Old address
to the New address.
LCR Utilities
Find LCR Devices
If the node address of the connected LCR is not known,
a search for the node address will need to be done. The
wider the search range, the longer it will take the pro-
gram to complete its search. It is recommend to first try
the default value of 250 for new LectroCount registers.
If this is not found, begin with small ranges.
First
Enter the value at which to begin the node search.
Last
Enter the value at which to end the node search.
Search
Click on search to begin the search for the node address
across the range from First to Last. When the search is
complete, a window will display all LCR nodes found
within the specified range.
The wider the entered range, the longer it will take for
the program to perform the search.