Controlled Products Systems Group 6300-080 - Manual (Page 36)

3.2 Switch Settings
The two DIP-switches located on the circuit board are used to program the operator to operate in
various modes and to turn on or off various operating features. Whenever a switch setting is
changed, power to the operator must be turned OFF and then turned back on for the new setting to
take affect. Check and review ALL switch settings prior to applying power to the operator.
SW 1 (TOP SWITCH)
SWITCH FUNCTION SETTING DESCRIPTION
1 and 2 Relay 1-OFF 2-OFF
1-OFF 2-ON
1-ON 2-OFF
1-ON 2-ON Relay activated only when gate is FULL OPEN.
Relay activated whenever gate is NOT CLOSED.
Relay activated when gate is OPENING and OPEN.
Relay activated when gate is OPENING and CLOSING.
3 Open Loop
Logic Output
OFF
ON Output of loop detector in OPEN port is switched to terminal 12.
Output of loop detector in OPEN port feeds directly to processor.
4 Auto-Close
Timer
OFF
ON Auto-close timer is OFF. Manual input required to close gate.
Auto=close timer is ON. Adjustable from 1-23 seconds.
5 Slide Gate
Swing Gate
OFF
ON Switch is in the OFF position for slide gate operators.
Switch is in the ON position for swing gate operators.
6 Single Button
Control
OFF
ON Switch must be OFF when 3-button control is used.
Switch must be ON when single button control is in use.
7 Bi-parting Gates
Single Gate
OFF
ON Switch is OFF when bi-parting (primary/secondary) gates are
used.
Switch is ON for single gate operation.
8 Tamper Protect OFF
ON Tamper protect is turned OFF.
Tamper protect is turned ON.
SW 2 (BOTTOM SWITCH)
SWITCH FUNCTION SETTING DESCRIPTION
1 Direction
Primary
OFF
ON Changes direction of PRIMARY operator. Set so that the operator
runs in the OPEN direction upon initial activation after power-up.
2 Direction
Secondary
OFF
ON Changes direction of SECONDARY operator. Set so that the
operator runs in the OPEN direction upon initial activation after
power-up.
3 Self Test OFF
ON Normal operation.
Self test. Operator must be disconnected from gate to run test.
4 Motor Control OFF
ON
Switch is OFF when both primary and secondary operator motors
are powered from main terminals 4 and 5. Applies to operators
originally manufactured with 4501, Rev O boards or lower).
Switch is ON when secondary operator motor is powered from the
secondary motor terminals. Applies to operators manufactured
with 4501, Rev P boards and higher, and all 4502 boards.
5 Shadow Input OFF
ON Terminal 15 is a standard REVERSE input with this switch OFF.
Terminal 15 is a SHADOW input with this switch ON.
6 Gate Overlap OFF
ON Primary and secondary operators start at the same time.
Secondary operator starts 1-2 seconds prior to the primary
operator.
7 Not Used OFF Leave in OFF position.
8 Not Used OFF Leave in OFF position.
Page 36 6300-065-E-4-08