Controlled Products Systems Group 6300-080 - Manual (Page 15)

SECTION 1 - INSTALLATION
Prior to beginning the installation of the swing gate operator, we suggest that you become familiar
with the instructions, illustrations, and wiring guide-lines in this manual. This will help insure that your
installation is performed in an efficient and professional manner.
The proper installation of the vehicular swing gate operator is an extremely important and integral part
of the overall access control system. Check all local building ordinances and building codes prior to
installing this operator. Be sure your installation is in compliance with local codes.
1.1 Specifications
Class of Operation: Model 6300 - Class I, II, III, IV
Type of Gate: Vehicular Swing Gates Only
Horsepower: 1/2 or 1 HP
Voltage / Phase: 115, 230, 460 VAC Single-Phase
Current: ½ HP: 5.4 @ 120V; 2.7 @ 230V; 1.35 @ 460V
1 HP: 14.0 @ 120V; 7.0 @ 230V; 3.5 @ 460V
Max Gate Weight: 1/2 HP - 600 Lbs.; 1 HP - 800 Lbs.
Max Gate Length: 1/2 HP - 18 Ft.; 1 HP - 22 Ft.
Cycles / Hr: 60/Hr
Speed: 90° in approximately 15-18 seconds
Entrapment Protection: Primary - Inherent adjustable clutch (Type C)
Secondary - Inherent entrapment sensing system (Type A)
and provision for connection of a non-contact sensor (Type
B1)
31.00 16.25
13.50
Figure 1
6300-065-E-4-08 Page 15