Controlled Products Systems Group 6300-080 - Manual (Page 29)

2.2 Control Wiring
DOORKING, INC., INGLEWOOD, CA 90301
Title:
Date: Rev. Dwg. No.
Fire
Dept
OPEN
CLOSE
STOP
A
Z
Call
Telephone
Entry
Stand-Alone
Card Reader
Stand-Alone
Keypad
Key
Switch
1
2
3
4
Diagram at right is for illustration purposes. The actual placement of the
secondary protection devices is dependent on the specific installation
requirements.
Secondary entrapment protection devices must be installed with this gate
operator. This protection may be provided by non-contact or contact
sensors, or a combination of both.
Secondary device wiring shows inputs to the circuit board only. Photo-cells
must be supplied with power.
Refer to the safety instructions in the front of this manual for more
information.
Controls must be installed a minimum of 10-feet from the gate or installed in
such a way that the person using the control cannot come in contact with
the gate or gate operator.
All inputs to the 4502 circuit board are Normally Open (N.O.).
9/07 A 4502-CNTRL-1
Model 6050, 6100 and 6300
Control and Secondary Device Wiring
Power 24 V
Relay
Common
Mag
Lock
2
3
1
4
Radio receiver power only. Power here is limited to 250 ma.
Magnetic lock power (24-Volt) and logic output. Power is shut off .5 sec. Prior to gate
starting and remains off while gate is opening and in the open position.
Reverse input functions only when gate is in the closing cycle.
Must use a DoorKing 3-button control station. Others will not work.
B
Close direction non-contact sensor. Reverses gate
during the closing cycle only. Holds gate in the full
open position until obstruction is cleared.
A
Open direction non-contact sensor. Stops the gate
in the opening or closing cycle only. Gate resumes
normal operation when the obstruction is cleared.
4502-010
Circuit Board
Auxiliary Terminals
123
45
6
789
1
0
1
1
1
2
1
3
1
4
15
16
1
7
1
8
19
20
1 2 3 4 5 6 7 8
B
A A
6300-065-E-4-08 Page 29