Controlled Products Systems Group 6300-080 - Manual (Page 19)

25 30
• The concrete pad is sized so that
there is a minimum of three (3)
inches of concrete around the
perimeter of the pad.
• Attach the gate bracket to the gate
so that the top of the mounting
plate is 5 inches above the top of
the gate bracket as shown in
Figure 7. This will keep the crank
and connecting arms level (see
page 22, Figure 10).
• The height requirement can also
be ascertained by placing the gate
bracket so that it is 5 1/2 inches
(10 1/2 - 5) above the bottom of the base plate, or above the top of the concrete pad. Figure 6
• The position of the gate bracket on the gate is directly related to the height of the concrete
pad above ground level. If allowed by local codes, the top of the concrete pad can be flush
with ground level as shown in Figure 7, which will allow the gate bracket to be lower on the
gate.
12
Gate Hinge
Ga
te
Frame
Determined by
soil conditions
and local code.
Ground Level
Gate Bracket
11
5
Figure 7
6300-065-E-4-08 Page 19