Controlled Products Systems Group 6300-080 - Manual (Page 21)

1.3.2 Pad Mounted Operators
1. Place the operator on its side and remove 4 bolts and 4 nuts from the bottom frame
(Figure 9).
2. Gently place the operator on the pad mounting assembly being sure to align all 4 nut
plates and the 4 mounting bolts.
3. Replace the 4 bolts and 4 nuts removed in step 1 to secure the operator to the pad
mounting assembly.
4. Route conduits into the operator at this time.
Output
Shaft
Nut Plates
Nut Plates
Operator Frame
Remove Bolts
Remove Bolts
Remove Nuts
Remove Nuts
Output
Shaft
Figure 9
6300-065-E-4-08 Page 21