Controlled Products Systems Group 6300-080 - Manual (Page 20)

1.3 Mounting the Operator
1. Remove the operator from the shipping carton.
2. Remove the cover from the operator.
3. It is advisable to remove the conduit knockouts (as required) prior to mounting the
operator onto the operator base plate.
1.3.1 Post Mounted Operators
1. Place the operator on its side and remove 6 bolts and 4 nuts from the bottom frame
(Figure 8).
2. Gently place the operator on the mounting post assembly being sure to align all 6 nut
plates and the 4 mounting bolts.
3. Replace the 6 bolts and the 4 nuts removed in step 1 to secure the operator to the
mounting post assembly.
4. Route conduits into the operator at this time.
Figure 8
Output
Shaft
Output
Shaft
Nut Plates
Nut Plates
Operator Frame
Remove Bolts
Remove Bolts
Remove Nuts
Remove Nuts
Page 20 6300-065-E-4-08