Conveyor components, Divert, Merge – FlexLink Configura User Manual
Page 20: Divert/merge, Pallet handling components, Locating station, Support, Stop cylinder, Sensor bracket

Conveyor Components
A Divert, Merge or a combined Divert/Merge component can be connected alongside or
to the ends of an existing beam on the drawing area. You can set the direction and the
angle of these components.
Divert
A divert is used for guiding the flow of products off the highway into a satellite.
Merge
A merge is used for guiding products from a satellite back to the highway.
Divert/Merge
A divert/merge permits products to:
-
Be guided into a satellite
-
Be returned back to the highway
-
Circulate on the satellite
To connect a Divert, Merge or a combined Divert/Merge component to the end of a
beam, proceed as follows:
1. Select the component and move it to the drawing area. With the arrow of your mouse
pointer, point at the end of the beam. When the two components snap, click.
2. Move the mouse pointer to determine the direction and the angle of the component.
3. Click to confirm.
To connect a Divert, Merge or a combined Divert/Merge component along the side of a
beam, proceed as follows:
1. Select the component and move it to the drawing area. With the arrow of your mouse
pointer, point along the side of the beam. When the component is in the desired
position, click.
2. Move the mouse pointer to determine the angle.
3. Click to confirm.
Pallet Handling Components
All pallet-handling components are positioned in the same way: Move the component close
to the conveyor until it snaps alongside the conveyor. Click it into position.
Locating Station
The Locating Station component is connected to the highway or satellite conveyor.
Support
The Support component is only used on the XK system and is connected to the locating
station.
Stop Cylinder
The Stop Cylinder component is connected to the highway or satellite conveyor.
Sensor Bracket
The Sensor Bracket component is connected to the highway or satellite conveyor.
Note:
-
To place a Divert, Merge or a combined Divert/Merge component in an exact
position on a main conveyor, use a Reference Point from the Line Drawing 1 tab
(see image below).
20
© Copyright Configura Sverige AB 2004. All rights reserved. Reproduction, copying or distribution to a third party is prohibited unless
consent in writing has been given by the owner.