FlexLink X45 User Manual
Conveyor system x45, Parameter settings tool
Table of contents
Document Outline
- 1 Summary
- 2 Hardware
- 3 Software
- 4 Installation
- 5 Connect
- 6 Software download
- 7 Adjusting parameters
- 8 Calibration
- 1 The Calibrate page can be found under the menu Tools.
- 2 In the address field the correct motor address should be filled in.
- 3 When the button
- 4 enable calibration is pressed the calibrate function is activated.
- 5 The motor unit can then be set in the accurate position by stepping up and down with the arrows. Look in the user documentation for the correct angle for each function.
- 6 To save this value the button
- 7 set home position is pressed.
- 9 Diagnosis